Roofing Oak Brook homes the way we have since 2002 — measured on site, priced in writing, and finished the way we would want our own roof finished.
Pick a service to see how we handle it and what the job usually looks like on a Oak Brook roof.
This is the work our name is attached to. Two decades of tin roofs on houses, churches, barns and additions, installed by crews who cut the trim on site instead of forcing something that almost fits.
Steam and hand work, never a hammer and chisel on your roof. Then we check the eaves for the damage the ice already did.
After a storm we walk the roof, photograph everything we find, and write an itemized estimate you can hand straight to your adjuster.
Reflective coatings keep a metal roof cooler in summer and seal up the small stuff before it turns into a leak.
If two other people have caulked it and it still leaks, call us. Most stubborn leaks turn out to be flashing, a valley, or a fastener nobody thought to check.
Metal, shingle and low slope work on buildings where a leak costs you more than a wet ceiling. Free estimates, same as anywhere else.
A careful walk over the whole roof — panels, shingles, valleys, flashing, fasteners — plus the attic side when there is a way in. You get photos and a straight answer.
The layer you never see is what keeps water out on the ugly days. We do not thin it out to save a few dollars on a bid.
Hard wind lifts shingles and works panel fasteners loose along the edges, which is exactly where the next storm gets underneath. We refasten, replace and reseal.
Full tear off, decking checked board by board, then a new metal or shingle roof over proper underlayment. You get the price and the start date before anything comes off.
Low slope roofs fail at the joints and around anything that sticks through them. That is where we start, not out in the middle of the field.
Most roofs somebody has called a lost cause are not one. We repair what can be repaired, and we tell you honestly when a repair will no longer hold.
Backed out screws, split washers, rust starting at a seam, a panel lifted at the eave. These are our roofs, and most of the time a repair is all it takes.
Careful footwork, matched materials, and flashing done the way it was done when the roof went on.
Storm damage does not wait for business hours. We get the opening closed, photograph it for your insurance, and put the real fix on the schedule.
Repair or replace, we handle both, and we work from what the roof actually needs rather than from what an adjuster might approve.
New skylights set into metal or shingle roofs, with the flashing kit the roof actually calls for rather than a tube of sealant.
Guards installed as part of a roof job or on their own. Either way we check the hangers and the pitch while we are up there.
The edge of a roof is where most trouble starts. New fascia, new soffit, wrapped or painted so it stays sound.
We still shingle plenty of roofs. Cracked, curled and blown off shingles get replaced, and the valleys and flashing get reworked while we are up there.
Roofing Brothers began in 2002 as a family roofing company in Morganton, North Carolina, and it is still run the way it started. Homeowners in Oak Brook reach that same outfit — the one that has been setting metal panels and laying shingles for over twenty years — through our network of local crews.
In a city the size of Oak Brook, word travels fast about who does good work and who does not. That suits us fine. We would rather put one roof on right and have the neighbors ask about it than chase volume all over Illinois.
Nothing fancy — free estimates, honest answers, and roofs that go on straight.
The same family started this company putting metal roofs on neighbors houses in 2002. It has never been sold, franchised or handed off to a call center.
Around twenty standard metal colors, and the chart comes out with the estimate so you can hold it up against your siding and shutters before you commit.
You get a start date and we hold to it. If weather moves your job we call you, rather than leaving you watching the driveway.
Beds get covered, tear off gets hauled as we go, and a magnet goes over the drive before we pull out. Your yard should look like we were never there.
Somebody comes out, measures, gets on the roof, and leaves you a written price. No charge, no obligation, and no number that expires if you do not sign today.
Common questions from Oak Brook, IL homeowners about metal roofs, repairs and what a roof costs.
Much less than people expect. Over solid decking with underlayment under it, a Oak Brook metal roof sounds about like a shingle roof from inside the house. The loud tin roof people remember was screwed straight to open purlins over a barn with nothing underneath.
Often, yes. Plenty of the Oak Brook roofs we get called to look at need flashing reworked or a section refastened, not a whole new roof. We will tell you honestly which one you are looking at, and if it is repairable we would rather repair it.
Most Oak Brook metal roof jobs land somewhere between about $12,000 and $30,000 in 2026, depending on square footage, pitch, panel type and how much tear off there is. Standing seam runs higher than exposed fastener panels. We measure before we quote, and the estimate is free.
That is most of what leak work is. Water runs along decking and rafters before it ever drips, so the stain on your Oak Brook ceiling is rarely under the actual hole. We work back to the real entry point, fix that, and check the rest of the roof while we are up there.
A typical Oak Brook shingle roof runs roughly $8,000 to $18,000 in 2026 for an average single family home, and more if the deck has rot or the roof is steep and cut up with dormers. We do not price off a satellite photo — somebody comes out and measures.
We do. After a storm we photograph the damage on your Oak Brook roof and write an itemized estimate you can hand to your adjuster. We do not file the claim for you and we will not promise you what an adjuster is going to approve — that is their call, not ours.
What people say once the crew has packed up and gone home.
"Standing seam on our log home. The panels are dead straight and the ridge work is clean. You can tell they have done a few of these."
"Thank you so much to the entire crew at Roofing Brothers for our amazing new tin roof! You were amazing to work with and I couldn't recommend you to others enough! Great communication, pricing, color options, efficiency, and HONESTY! If anyone needs a new roof, I highly recommend this crew! Phenomenal job."
"Roofing Brothers do excellent work. They've completed several projects for me and every time the quality has been top notch. They're reliable and take pride in what they do. I highly recommend them!"
Looking for a roofer just outside Oak Brook? These areas are covered too.